Startechcom ARMDUAL Uživatelský manuál

Manual Revision: 12/12/2014For the most up-to-date information, please visit: www.startech.comARMDUALDesk Mount Articulating Dual Monitor Arm with Cab

Instruction Manual75. Slide the DEK (12) onto the support post so that it rests on the collar. Once adjusted to the desired height, tighten into plac

Instruction Manual83. Using a Phillips screwdriver, tighten the screws until the bracket is rmly attached to the back of the display.WARNING! Do not

Instruction Manual9Attaching the LCD Arm Assembly2. Tighten the set screw using the 2.5mm Allen Wrench (10).1. Slide the LCD Arm Assembly (1 or 2)

Instruction Manual103. Place the Cover (11) over the mounting post and insert 1 x M6x12mm Phillips Screw (16) with 1 x Plastic Washer (15). Tighten u

Instruction Manual11Cable ManagementNote: When attaching cables and routing through the cable management channels, ensure that you leave enough slack

Instruction Manual12Adjusting LCD Arm ResistanceWARNING! Forced movement of the LCD Arms or Mount Brackets without loosening the screws may damage the

Instruction Manual13To increase / decrease the pan / swing resistance, adjust the set screw located on the top of the Mount Bracket joint, using the 4

Instruction Manual14SpecicationsWeight Capacity 30 lbs (13.6 kg)Max Display Size 24”VESA Compatibility 75x75 mm and 100x100 mmMaximum Extension 18.66

Instruction Manual15Technical SupportStarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solut

Hard-to-nd made easy. At StarTech.com, that isn’t a slogan. It’s a promise.StarTech.com is your one-stop source for every connectivity part you need.

Instruction ManualVESA (Video Electronics Standards Association) Compatibility Startech.com monitor mounting products are engineered in accordance wit

Instruction ManualiTable of ContentsIntroduction ... 1Packagi

Instruction Manual1IntroductionPackaging Contents

Instruction Manual2Product Diagram

Instruction Manual3InstallationWARNING! It is the installer’s responsibility to ensure that the combined weight of all components does not exceed the

Instruction Manual43. Using the 4 hex screws removed in Step 2, install the Grommet Plate (7) to the base of the pole.4. Remove the screw and 2 was

Instruction Manual5Desk / Grommet Mounting1. Adjust the height of the Desk Clamp (3) to t your desk surface (if applicable).2. Place the 4 Plastic

Instruction Manual63. Desk Clamp: Place the Desk Clamp (3) opening around the edge of your desktop in your desired location and tighten by hand to se